2004 Winnebago Sightseer Motorhome Trailer Hitch
2004 Winnebago Sightseer Motorhome Suspension Enhancement
2004 Winnebago Sightseer Motorhome Vehicle Sway Bars
2004 Winnebago Sightseer Motorhome Windshield Wiper Blades
2004 Winnebago Sightseer Motorhome RV Vents
2004 Winnebago Sightseer Motorhome RV Covers
2004 Winnebago Sightseer Motorhome RV Roof Membrane
2004 Winnebago Sightseer Motorhome RV Camera
2004 Winnebago Sightseer Motorhome RV Interior Lighting
2004 Winnebago Sightseer Motorhome RV Exterior Lighting
2004 Winnebago Sightseer Motorhome RV Jack Pads
2004 Winnebago Sightseer Motorhome RV Jumper
2004 Winnebago Sightseer Motorhome RV Antenna and Radio
2004 Winnebago Sightseer Motorhome RV Air Conditioner
Videos
for Winnebago Sightseer Motorhome Owners
Help Articles
Expert Answers
It appears that all you going to need is the Replacement Lippert 4-Point Leveling System Control Brain Wiring Harness #LC178278. This wiring harness will allow you to plug your new Replacement Lippert Leveling Control Brain for 4-Point Leveling…
Before you replace your unit try first, removing the screws holding your unit to your Winnebago. Then, remove the plug at the rear of the unit, wait 60 seconds, and plug back in. This will preform a reset on the unit and may solve your issue. This…
For the 17k Level Best jack replacements we have the part #LC359275 that you referenced. For 10k legs you'd instead want the part #LC359278.
The #LC359281 is for the 17K capacity Kwikee Atlas Level Best jack. It only provides the cylinder itself. For the entire assembly, use #LC359275.
That's a good question and the difference between the two SnapPad Jack Stand Pads for Motorhome are different shapes and depths, it isn't solely the notch in the center. I added photos of the two pads side-by-side so you can see the…
Yes, the SeeLeveL RV Holding Tank Monitor for fresh, gray, black - water pump and heater switch, #SE74VR is designed specifically to be a replacement for older tank monitoring systems. The SeeLeveL #SE74VR uses sensors that are sold separately for…
The smoke might let a little more light through it, but nothing that noticeable. And aside from that either color does not have the reputation as lasting longer than the other. The white version is part #BV0554-01 and the smoke version is part…
I would be happy to help! The Curt Trailer Hitch Receiver #C15845 you were looking at is designed to fit the 2003 Ford F-350/450/550 Cab and Chassis motorhomes, and will not work on your 2003 Thor Four Winds Hurricane built on the Ford F53 chassis.…
The SeeLeveL RV Holding Tank Monitoring System, #SE39VR operates from a 12 VDC power source. The installation consists of mounting the display inside the RV, cutting and fastening the senders to the sides of the holding tanks, connecting wiring, and…
We may have a trailer hitch that will work with your 2003 Coachmen Mirada, however the Curt Custom Fit Class V Trailer Hitch, #C14048, that you referenced will not fit Class A motor homes. Before installing a Class V trailer hitch on your Mirada, I…
Yes, the Optronics trailer clearance light part #MC44AB is the same as the Winnebago 111102-02-000 clearance light.
We do offer a sealant that will work on fiberglass, but the part #49329 that you referenced is not designed for it. Instead I would recommend the TremPro 644 Silicone Sealant #0160297 as it has been confirmed to work on fiberglass.